This can be used to clean off any unstable software and make a clean start. The first step especially if it's used is to flash the firmware. This adapter requires more than just fingernails to remove in testing, but a keychain pocket knife screwdriver or nail file was sufficient to safely remove it.įile System information Firmware Initial Firmware Setup This adapter also inserted fully and had a rubber washer to buffer any drops combined with an Otter case the adapter is nearly flush with the Otterbox armor.
while there is the hazard of magnetic particles connecting the two poles are 2mm apart and it is easier to see any foreign objects as the cable side of the connector has a blue LED allowing it to also be found easily in a dark room. In testing the four or five pin USB adapters permit a data connection but if you do any metal work with steel it will attract magnetic particles as happened in testing, this adapter experienced a melt-down and nearly a fire one evening after falling to the floor in a workspace.Īnother tested magnetic adapter has a coaxial positive and negative connections(pin and surrounding ring) It has the data pins shorted to put the N900 into fast charge mode. No leverage to snap off your N900's fragile USB port from the PCB. There are several magnetic adapters available to both plug the USB port and also ensure a safe break-away should the N900 be dropped. Qi Inductive Charging Universal Add-On Installation Magnetic Charge Port Adapter The USB port can be easily unplugged if needed for use in USB host, 3G modem, and mass storage modes.
#Supertux 2 n900 mod
The latter is important, especially if you don't feel confident in taking your N900 apart to reinforce the port.īridging the gap between a non-permanent hardware mod and an accessory the universal Qi inductive charging add-on pads have been installed both over and under the stock and Mugen battery covers, the semi-permanent installation into the microUSB port reduces dangerous cable leverage and USB port wear to nearly zero and the nearly flush USB port plug also protects the USB port from foreign object damage making the inductive charging add-on even more important to N900 owners than most users. This can be done by filing them down carefully with a small file. Information on this is covered in great extent on Īnother common modification is to remove the locking pins on all your microUSB cable connectors. Therefore it is highly recommend to reinforce your USB port by soldering the casing of the USB to the PCB. If you are not careful with it, the port can be ripped from the PCB.ĭue to the design of the port if this occurs, it can be very difficult to repair successfully. One of the most common issues with the N900 is the surface mounted USB port. Recommended Hardware Modifications USB Port Information on the specs can be found on the N900 Hardware Subsystems page. Information on all recommended hardware accessories is on the N900 Accessories page. This page will mainly link all the useful bits of the wiki and other useful information together. This page is to provide a generic guide to getting started with good foundations.
Since the N900 has been released many developments have been made by the community. 6.1.1.1 Further reading on My Nokia and cherry.3.2 Cloning a New N900 with BackupMenu Backup Files.
0 kommentar(er)
